If your power steering pulley needs to be replaced, but you don’t have a puller handy, don’t worry! In this article, we’ll teach you how to remove it without the need for one.
Tools You’ll Need
When it comes to removing a power steering pulley, you’ll need the right tools. Here’s what you’ll need:
1. A puller tool
2. A socket wrench
3. A ratchet or torque wrench
4. A breaker bar
5. A bucket or a large container
6.WD-40 or similar lubricant
7. Clean rags
8. Safety goggles or glasses
9. Sandpaper (optional)
10. Latex gloves (optional)
11. Jumper cables (optional)
If you don’t have a power steering pulley removal tool, buy one before beginning this project! There are many varieties on the market, so be sure to find the right one for your vehicle. Some of the more popular tools include the following:
1. Pulley puller: This is a tool that uses leverage to remove power steering pulleys without the use of hand tools. It is typically made from metal and has a handle at one end and a jaw at the other end that can grip onto the pulley tightly.
2. Socket wrench: This is an all-purpose tool used for changing tires, removing nuts and bolts,
Preparation
If you have a power steering pulley that needs to be removed, there are a few things you’ll need before you start:
-A power steering pulley puller
-A manual or automatic transmission fluid flush
-A quart of oil
– A funnel
-A bucket or container
1. Start by flushing the manual or automatic transmission fluid system. Pour a quart of oil into the bucket and put it in the back of your car. Turn the car off and let the oil drain into the bucket. Once the bucket is full, start the car and let it run until it’s empty.
2. Next, take the power steering pulley puller and insert the arms into the holes on either side of the pulley. Make sure that the teeth on the arm are lined up with the teeth on the pulley. Hold onto the puller with one hand and use your other hand to twist it in a counterclockwise direction. Be careful not to damage anything while you’re doing this.
3. Once the puller has been twisted all the way around, release it and carefully remove it from around the pulley. Be sure to hold onto any wires that are attached
Removal
If you own a power steering pulley and have no puller, don’t fret! With a little bit of creativity and some elbow grease, you can remove your pulley without any help.
Materials:
-Power steering pulley
-Socket wrench (with a universal joint)
-Socket extension (if needed)
-Jack or stands
-Torque wrench (if needed)
-WD-40 or similar lubricant
-Rag
-Instructions:
1. Park the car in a safe place and turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the wheel.
4. Remove the serpentine belt by removing the tensioner and idler pulleys using a socket wrench and extension, if necessary. [Note: The tensioner must be removed before the belt can be removed.] CAUTION: When removing the tensioner, use caution not to pinch the belt between it and the pulley. If this happens, it is possible to damage both parts.
5. Remove the power steering pump cover by unscrewing it from the top of the pump using a socket wrench and extension. On 2007+ models,
Conclusion
If you’re like most people, you’ve probably had to remove a power steering pulley from a car at some point in your life. Unfortunately, without the right tools, removing it can be a frustrating and time-consuming process. In this article, we’ll show you how to remove a power steering pulley using only a wrench and some basic hand skills. Be sure to read through the entire article before beginning so that you understand the steps involved and don’t end up damaging your vehicle in the process!