Do you hate the cup holder that comes with your Graco car seat? It’s a permanent fixture and seems like it takes up a lot of space, especially when there are other more important things to put in that spot. If you want to remove the cup holder from your Graco car seat, follow these simple steps: 1. Remove the screws that secure it to the base of the seat. 2. Lift up the cup holder and set it aside. 3. Reattach the screws and tighten them down. You’re done!
Materials You Will Need
Materials you will need:
–Graco car seat with cup holder
-Hole drill bit size M (1/4 inch)
-Screwdriver
-Tape measure
-Ruler or a straight edge
-Cup holders from other types of vehicles
-Paint, if desired
1. To remove the cup holder from your Graco car seat, start by taking off the screws that hold it in place. Make sure to keep the screwdriver handy in case you lose one! If you don’t have a screwdriver, you can use a hole drill bit size M (1/4 inch). You’ll need to make a small hole at the top of the cup holder and then use the screwdriver to remove the screws. Once the screws are removed, take off the cup holder.
2. Next, measure the width of your hole and drill it using your hole drill bit. Make sure to go slowly so that you don’t damage your car seat or yourself. Once your hole is drilled, use your tape measure to determine how wide your new cup holder should be. Cut out your new cup holder and place it over your original one. Screw it into place using the screws that were removed in step 1.
3. If you want to paint your new cup holder, now is the time to do so! Paint both pieces of furniture black and then let them dry completely before mounting them back onto
Instructions
If you want to remove the cup holder from your Graco car seat, follow these simple steps: 1. Remove the front cover of the car seat by popping it off by pulling up on one side and then tugging down on the other side.
2. Lift up the armrest and slide it out of the way.
3. Then, take off the four screws that hold the cup holder in place (two on each side).
4. Now you can remove the holder by sliding it out from both sides. Make sure you grab onto the bottom part first so it doesn’t fall off while you’re removing it!
Conclusion
Getting your Graco car seat out of the vehicle can be a breeze with a few simple tools and some patience. First, unplug the car seat from the electrical outlet. Next, remove the screws that keep the base of the car seat attached to the vehicle. Finally, lift up on one side of the car seat until it pops free from the base. Be sure to store all of your removed parts in a safe place so you can put everything back together quickly when you’re ready to take your baby home!