If you’re experiencing problems with your Chevy 350’s power steering, it might be time to take it in for service. Here’s a guide on how to do it without any drama.
Tools You’ll Need
To remove the power steering pump on a Chevy, you’ll need a few tools. You’ll need a socket wrench, a funnel, and a bucket or container.
The socket wrench needs to be a 1/2-inch or 13mm size. The funnel needs to be wide enough to fit inside the socket wrench and have a lip on the top that fits around the bolt head. The bucket or container needs to be big enough to hold the power steering fluid.
1) Park the car so that it is facing straight ahead.
2) Open the hood of the car by pressing down on one of the hood release buttons.
3) Place the socket wrench over the bolt head and tighten it in a clockwise direction. Be sure to use plenty of pressure when tightening the bolt, because it may be difficult to remove it with just your hands.
4) Carefully pour out all of the power steering fluid from the funnel into the bucket or container.
5) Once all of the fluid has been drained from the funnel, gently remove the bolt from the socket wrench.
Location of Pump
To remove the power steering pump on a Chevy, you will need to locate the pump on the car. The pump is located near the steering column on the drivers side. To access it, you will need to remove the front wheel.
Removal Procedure
To remove power steering pump on a Chevy, follow the following procedure:
1. Remove the steering wheel.
2. Disconnect the power steering hose from the pump.
3. Turn the fuel valve off and disconnect the fuel line from the pump.
4. Lift out the pump by grabbing hold of the output gear and pulling it out of the housing.
Replacement Procedure
If you are experiencing problems with your power steering, there is a good chance that the pump located on the steering rack has failed. The replacement procedure for this pump is relatively straightforward, and can be done in a few hours with the use of a wrench.
The first step is to locate the power steering reservoir. This is located on top of the engine near the firewall. Once you have located it, you will need to remove the two Phillips head screws that hold the cover in place. Once these screws are removed, you will be able to lift up the cover and access the pump.
To replace the pump, first remove the old pump by unscrewing it from the bracket. Make sure to keep all of the original parts in tact so that you can re-install them correctly when you are finished. Next, insert the new pump into the bracket and tighten it using the three screws that were previously removed. Finally, reinstall the cover and screw it in place.
Tips for a Successful Removal
If you’re attempting to remove power steering pump on a Chevy, there are a few tips that will help make the job easier.
The first thing you’ll need is some patience. The process of removing a power steering pump can be difficult, but it’s definitely worth it in the long run.
Another tip is to use plenty of lubricant. This will help reduce the amount of friction that exists between the parts, making the removal process much smoother.
And lastly, don’t be afraid to use brute force if necessary. If something seems stubborn, give it a good push until it comes loose. With a little bit of effort, you should be able to remove your power steering pump on a Chevy without any problems.