If your car is having trouble steering, it might be time to replace the power steering pump. Here’s how to do it:
1. Park your car in a safe location.
2. Turn off the engine and remove the key from the ignition.
3. Open the hood and locate the power steering pump. It looks like a large water hose with a cone on top.
4. Lift up the cone and disconnect the power steering pump from the engine.
5. Remove the old power steering pump by unscrewing the bolts that hold it in place. Be careful not to lose any of the sealant that was used to Install the new power steering pump!
6. Pour a small amount of soap into a bucket or sink, and fill it with water.
7. Place the old power steering pump in the soapy water and rinse it well with cold water. Be sure to get all of the soap off!
8. Let the old power steering pump dry before replacing it on your car’s engine.
What To Look For When Shopping For A Power Steering Pump
When shopping for a power steering pump, there are a few things you should look for. First and foremost, you will want to make sure the pump is compatible with your car. Next, you will want to decide what type of pump you need. Finally, you will need to find a reputable dealer or supplier.
When it comes to compatibility, make sure the pump is compatible with your car. Some cars use proprietary pumps that can only be replaced by a dealer. Others use standard pumps that can be replaced by anyone with basic tools. If you don’t know whether or not the pump is compatible, ask your mechanic.
When it comes to types of pumps, there are three main options: mechanical, hydraulic, and electronic. Mechanical pumps are the oldest type and use gears and cams to move the fluid. Hydraulic pumps are more modern and use pressurized fluid to move the fluid. Electronic pumps are the newest type and use digital controls to move the fluid.
Finally, when looking for a power steering pump, make sure you find a reputable dealer or supplier. Power steering pumps can be expensive and it’s important to get one that is going to last long term.
Alternatives to Replacing a Power Steering Pump
Replacing a power steering pump is a job that most drivers can do themselves, but there are some alternatives that may be easier or cheaper. Here are four options for replacing a power steering pump:
1. Use a manual transmission fluid pump:
This is the cheapest option and requires little skill or equipment. To use a manual transmission fluid pump, first loosen the bolts that hold the power steering pump to the steering rack and remove it. Next, use a wrench to unscrew the output hose from the pump and fit it over the end of the bolt on the rack. Connect the hose to the pump by screwing it in place. Once all of the bolts are tight, re-install the power steering pump and steer wheel.
2. Use an electric motor/pump:
This option is more expensive but requires less skill and equipment than using a manual transmission fluid pump. To use an electric motor/pump, first remove the screws that secure the power steering pump to the rack. Next, disconnect the electrical connector from the pump and unscrew it. Fit the electric motor/pump onto the connector and screw it in place. Re-install screws and connectors and tighten them .
3. Use a hydraulic pump:
This option is more expensive but requires less skill and equipment than using an electric motor/pump or a manual transmission fluid pump. To use a hydraulic pump, first remove the screws that secure the power steering pump to the rack. Next, disconnect the hydraulic connector from the pump and unscrew it. Fit the pump onto the connector and screw it in place. Re-install screws and connectors and tighten them.