If you’re having trouble controlling your Ford Explorer in the event of a power steering assist fault, there are a few steps you can take to reset the system. First, disconnect the battery and wait ten seconds. Second, restart the engine and hold the gas pedal to the floor while pressing the power steering assist button. Finally, reconnect the battery and drive your Ford Explorer as normal.
Ford Explorer Power Steering Assist Fault Symptoms
If you are experiencing power steering assist (PSA) issues in your Ford Explorer, there are a few things you can do to try and resolve the issue. First, make sure you have the latest software and firmware updates installed. If the issue persists, you may need to reset your PSA system. To do this, follow these steps:
1. Park your Ford Explorer in a safe location.
2. Turn off the vehicle’s ignition and remove the key from the ignition.
3. Disconnect the negative battery cable.
4. Unlock and open the driver’s side door.
5. Locate and remove the air bag module.
6. Remove the console cover and locate the power steering actuator box on the front of the console.
7. Reset the power steering assist fault by turning the screw located on top of the actuator box counterclockwise until it stops (3/8 turn).
8. Reconnect all wiring and components and test your PSA system again to ensure it is functioning properly
How to Reset Ford Explorer Power Steering Assist
If you are having trouble steering your Ford Explorer, there is a chance that the power steering assist is not working correctly. To fix the issue, you will need to reset the power steering assist.
To do this, you will need to remove the front panel of the car. You will also need to disconnect the power steering line from the gearbox. Once these have been removed, you can reset the power steering assist by pressing a button on the gearbox.
Ford Explorer Power Steering Assist Parts
Ford Explorer power steering assist parts are a common issue that can go wrong. If your Ford Explorer has a power steering assist issue, there are a few things you can do to try and fix it.
The first step is to check the power steering fluid level. If it’s low, you’ll need to add more fluid. Once the fluid is at the correct level, you can try turning the wheel to see if the power steering works. If it doesn’t work, you’ll need to replace the power steering assist unit.