Car ownership is a major commitment, and one that many people take on for a variety of reasons. Whether you’re a young person just starting out in the world or you have children who are just learning to drive, car ownership can be very convenient. However, there are times when you may need to use your car but don’t have the key! In this article, we will show you how to start your car without the use of the ignition switch.
What You’ll Need
If you’ve ever needed to start a car without the key, you know that it can be a little tricky. In this article, we’ll show you how to do it using a few simple items.
First, you’ll need a battery. Some cars come with a battery in the trunk, but most of them require an additional one. If your car doesn’t have a battery, you can buy one at any hardware store.
Next, you’ll need jumper cables. Jumper cables are essential for any car repair, and they’re also perfect for starting your car without the key. There are several different types of jumper cables out there, so find the ones that fit your vehicle best.
Finally, you’ll need a screwdriver or wrench. You’ll need this to remove the screws that hold the plastic cover on the ignition switch. Once the cover is off, you can access the ignition switch itself.
How to Do It
If you’re looking to start your car without the ignition switch, you’ll need some tools and know-how. Here’s how to do it:
1) Remove the battery cover. You can do this by either removing the screws that hold it in place or prying it off with a flathead screwdriver. Make sure to store the cover aside in a safe place, as you’ll need to replace it later.
2) Remove the two screws that hold in the steering wheel. Then, twist the wheel counter-clockwise until it comes off of the car.
3) It’s now time to access the ignition module. Start by removing the two bolts that hold it in place, then gently pull it out of the dashboard. You’ll also need to disconnect the wire from it (it’s a brown/black wire).
4) Next, remove all of the wires from the module (there are six of them). Once they’re all removed, you can simply throw them away or re-purpose them as needed.
5) It’s now time to install your new ignition module. Start by lining up the holes on the module with those on the dashboard, then screw it into place using
Tips for Safe and Successful DIY Car Ignition Switch Replacement
If your car won’t start because of a broken ignition switch, you can replace it yourself without having to take the car to a mechanic. This guide will show you how.
1. Make sure you have all the necessary tools and supplies before beginning. You’ll need a Phillips head screwdriver, T-8 Torx bit, wire cutters, electrical tape, and a hammer.
2. Park your car in a safe place so that you can work on it without fear of causing damage.
3. Open the hood of your car and locate the ignition switch assembly. It’s typically located near the front of the engine compartment.
4. Remove the screws that hold the switch assembly in place. Be careful not to lose these screws; you’ll need them later on when you reassemble the switch.
5. Once the switch assembly is free, gently pop it out of its socket. Set it aside for now.
6. Next, use your Phillips head screwdriver to remove the four T-8 Torx screws that hold the cover on top of the switch assembly. These screws are situated near each corner of the cover. Pry them loose with your T-8 Torx bit
Conclusion
If you’re like most people, you probably don’t know how to start a car without the ignition switch. If your car is inoperable or you just want to practice before something more important, there are a few simple steps that will get the job done. Be sure to read our full guide first so that you understand what you’re doing and why it’s important. After following these steps, you’ll be able to start your car in no time!