Have you ever had to strip old wax from a car? If so, you know it can be a tedious and time-consuming task. Not to mention, it can be frustrating when the wax stubbornly refuses to come off no matter how much you try. Fortunately, there’s an easier way—and it doesn’t involve using harsh chemicals. In this blog post, we will show you how to strip old wax from a car using nothing more than warm water and a cloth.
What You’ll Need
To strip old wax from your car, you’ll need a bucket of warm soapy water, a microfiber cloth, and some elbow grease. Start by filling the bucket with hot soapy water and placing the microfiber cloth in it. Hold the cloth against the car’s surface and start scrubbing away at the wax. Be sure to use circular motions to avoid harsh abrasive edges. Once all of the wax is removed, rinse the area off with warm soapy water and dry off with a clean microfiber cloth.
How to Strip Old Wax From Your Car
If you’ve ever tried to strip old wax from your car, you know it can be a tedious and time-consuming process. Here are five tips for getting the job done quickly and easily:
1. Use acetone or a similar solvent to soften the wax.
2. Remove the wax using a cloth, soft bristled brush, or a sturdy piece of sandpaper.
3. Rinse the area thoroughly with water to remove any residue.
4. Apply a new coat of wax to the area, if desired.
5. Repeat steps 2-4 as necessary until the wax is completely removed.
Tips for Stripping Old Wax From Your Car
When it comes to stripping old wax from your car, there are a few tips that can help make the process easier.
First, make sure that you have the right tools for the job. You’ll need a cloth or microfiber towel, a solvent-based stripper such as Mr. Clean Magic Eraser or WD-40 Dissolver, and a bucket or container to mix the stripper in.
To start, wet your towel with water and wring out the excess. Then, put the cloth on top of the waxed area and press down firmly. The stripper will start to dissolve the wax and remove it in layers. Be patient; it may take several hours to get all of the wax off.
If you’re using Mr. Clean Magic Eraser or WD-40 Dissolver, be careful not to overuse them – too much Stripper can damage your car’s finish. Just use enough to cover all of the waxed areas and work it into the surface with your towel until it’s completely dissolved.
Once all of the wax is gone, rinse off any residue with cool water and dry off your car thoroughly before applying any new wax or sealant.