Amaryllis are one of the most popular flowers in the world, and for good reason. They’re easy to care for, they come in a variety of colors and they make a beautiful addition to any home. However, like all plants, amaryllis need proper care in order to thrive. If you’re new to caring for amaryllis, or if you just don’t have time to take care of them yourself, don’t worry; we have you covered. In this blog post, we will teach you how to take care of waxed amaryllis bulbs so that they can last longer and look their best.
Identification
Waxing amaryllis bulbs is an easy way to keep them looking beautiful. Follow these instructions to get the best results.
To wax amaryllis bulbs:
1. Remove the damaged leaves and any brown section of bulb with a knife or sharp scissors.
2. Strip off about 1/4 inch of the papery outer layer of the bulb with a scalpel or small knife, being careful not to cut into the bulb itself.
3. Dip the tip of a heated metal spoon in hot wax and pour a thin layer on top of the stripped surface area (the wax will start to melt right away).
4. Hold the bulb in one hand and carefully spread the melted wax over the entire surface with your other hand, using circular motions (the heat from the metal spoon will help heat up the wax).
5. Continue pouring and spreading until all surfaces are covered (you may have to use two hands for this part).
6. Let cool until hard, usually taking about 10 minutes. Once cooled, peel off any hardened waxes with your fingers (or a knife if necessary).
How to clean waxed amaryllis bulbs
It’s time to clean waxed amaryllis bulbs! Here are three easy tips on how to get them looking their best again:
1. Start by soaking the bulbs in a bucket of warm water for about 30 minutes. This will loosen any built-up dirt and grime.
2. After the bulbs have soaked, use a soft brush to scrub off the excess dirt and debris. Make sure to focus on the base of the bulb where soil tends to accumulates most.
3. Rinse the bulbs well in cool water and then place them in a dry location to finish drying.
How to water waxed amaryllis bulbs
There are a few different ways to water waxed amaryllis bulbs. One way is to place the bulbs in a pot and fill the pot with water. Bring the water to a gentle boil and then turn off the heat. Let the bulbs sit in the hot water for 10 minutes. After 10 minutes, remove the bulbs from the pot and let them cool slightly. Then, pour cold water over them until they are fully submerged. Let the bulbs sit in this water for two hours. After two hours, drain the water and repeat this process two more times.
How to fertilize waxed amaryllis bulbs
Waxed amaryllis bulbs require pollination in order to set flowers. To fertilize these bulbs, you will need to purchase either a flower fertilizer or an amaryllis bulb fertilizer. Both options will need to be combined with water in order to fully hydrate the bulbs and give them the necessary nutrients. Pollination can also be done by hand if desired.
How to prune waxed amaryllis bulbs
Waxed amaryllis bulbs can be pruned any time of the year, but during the winter they are easiest to work with. Before pruning, remove any dead or diseased leaves. If the bulb is in a pot, carefully loosen the roots and move the plant to a new pot. If the bulb is in the ground, use a shovel to loosen the soil around it and then pull up the bulb. Cut off any brown branches that extend beyond the base of the bulb and cut off any dead flowers.
After pruning, water well and fertilize if necessary. Waxed amaryllis bulbs should be repotted every three years or when they reach maturity (approximately six years).
How to deal with aphids on waxed amaryllis bulbs
There are several ways to deal with aphids on waxed amaryllis bulbs. One is to use a sticky insecticidal film. Another is to use the oil of cloves or neem, applied directly to the bulb. A third is to use an herbal soap spray. Finally, you can vacuum them off.[1]
How to deal with scale on waxed amaryllis bulbs
When you grow a waxed amaryllis bulb, be prepared for scale! This plant is naturally resistant to pests, but scale can still cause problems if left unchecked. Here are some tips on how to deal with scale on waxed amaryllis bulbs:
1. Wash your hands before handling the bulb.
2. Avoid contact with the sap that may contain scale eggs.
3. Examine the plant daily for signs of scale and remove them as soon as you see them.
4. Use a appropriate insecticide or fungicide if needed to get rid of the scale. Follow the product’s instructions carefully.
Conclusion
Now that we’ve covered the basics of caring for waxed amaryllis bulbs, it’s time to talk about how to take care of them once they’re planted in the ground. First and foremost, make sure you water them regularly. Next, be sure to mulch around the bulbs so that they don’t get too much exposure to direct sunlight. And finally, keep an eye on them and remove any dead leaves or flowers as needed so that your bulb stays healthy and looking its best!