Graco car seats are one of the most popular infant car seats on the market. And for good reason: they’re reliable and affordably priced. But like all things, there is a downside—namely, how difficult it can be to take off the base of the seat. This guide will teach you how to remove the Graco car seat base in record time, so you can get your child out of the seat as quickly and easily as possible. From tips on how to remove the base without damaging it to methods for removing it from different types of vehicles, this guide has everything you need to get your Graco car seat off in a snap.
Uninstall the Graco Car Seat Base
If you need to uninstall the Graco Car Seat Base from your car, follow these instructions:
1. Remove the safety belt if it is installed.
2. Open the driver’s side door and remove the screws that secure the seat base to the car.
3. Carefully pull out the seat base from the car.
4. Store the seat base in a safe place until you are ready to replace it with another car seat base.
Locate the 4 Screws
To remove the Graco car seat base, locate the four screws located at the base of the seat. Once unscrewed, the base can be pulled off easily.
Remove the Graco Car Seat Base
Removing the Graco Car Seat Base is a relatively easy task that can help you get more storage space in your vehicle. The Graco car seat base attaches to the vehicle using several screws and bolts, so it’s not difficult to remove. However, before you can remove the base, you’ll first need to unscrew the fasteners. Once the fasteners are unscrewed, you can then lift up on the car seat base and pull it off of the vehicle.
Replace the Graco Car Seat Base
If your Graco car seat base is too tight to remove, you may need to use a wrench. Loosen the screws on each side of the base by turning them counterclockwise with a wrench. Gently pry up on one end of the base until it pops off. On some models, you may also need to unscrew the screws at the bottom of the seat. Once the base is off, you can slide it out from under the child’s car seat. If there’s still too much pressure on the bolt that attaches it to the car, you can try using a thicker washer between the bolt and nut in order to create more space.