If you’ve ever been stranded on the side of the road with an old car, you know just how frustrating it can be when your engine won’t start. And if you’re not mechanically inclined, that can turn into a real problem pretty quickly. In this blog post, we will teach you how to unstick an ignition switch on an old car in case you ever find yourself in this predicament. By following our simple tips, you’ll be able to get your car started in no time at all.
When To Worry About An Ignition Switch
If you have a car with an ignition switch that’s hard to turn, or doesn’t work at all, your first step should be to determine if it’s something you can fix yourself. If the switch is just stuck, you can try lubricating it and pushing or pulling on the cable to see if it moves. If the switch has broken off in the housing, you’ll need to take the car into a mechanic for repair.
How To Fix An Ignition Switch
If your car has an ignition switch, it might not be working properly. This can lead to a problem with the car being able to start. There are a few ways to fix an ignition switch on an old car.
The first way is to check the continuity of the switches wires. If there is no continuity, then the switch may need to be replaced. If there is continuity, then the switch may just need a new wire connector attached.
If the Switch is Broken:
If the switch is broken, it will need to be replaced. The easiest way to do this is to remove the ecu (engine control unit) and access the switch inside of it. Once you have access, you can either replace the whole switch or just reattach the wire connector
How To Unstick An Ignition Switch On A New Car
There are a few different ways to unstick an ignition switch on a new car. The most common way is to use a screwdriver or similar tool and pry the switch off of the casing. Another option is to use a hammer and tap the switch several times from the topside until it pops off. If all else fails, you can use a power drill with a 5/8-inch bit to remove the switch.
If you’re working on an old car, you’ll likely have to use a wrench to remove the switch. Start by removing any screws that are holding down the casing. Once that’s done, twist the wrench around theswitch until it comes loose. Be careful not to damage anything while you’re removing it!
Conclusion
If you’re ever stuck trying to unstick an ignition switch on an old car, don’t panic! There are a few things you can do in order to get it working again. The first step is to check the connections around the switch. Often times, these connections will become gummed up with corrosion and oil over time. If you can’t seem to loosen them up using a wrench, you might need to use a special tool designed specifically for this purpose. Next, try spraying alcohol onto the contacts and letting it dry for a few minutes. Finally, use a plunger or your hands to push and pull on the contacts until they pop free. Hopefully, after following these steps your car will start up again!