Brake fluid flush is a mechanical maintenance task that many car owners may not be aware of. When braking, the hydraulic system applies pressure to the brake rotors, which in turn causes them to stop spinning. Under normal operating conditions, brake fluid will wear away and evaporate over time, which can cause the rotor to become misaligned and eventually fail. By flushing the brake fluid every six months or so, you can keep your brakes in peak condition and avoid costly replacements.
What is Brake Fluid Flush?
Brake fluid flush is an important maintenance procedure for your car’s braking system. Brake fluid is essential for preventing brake fade and grinding, and it should be replaced every two years or 25,000 miles, whichever comes first. The best way to check if you need to flush your brakes is by doing a brake fluid test.
If you don’t flush your brakes every time you replace the fluid, over time the brake pads will become contaminated with sebum and other debris, which will cause them to wear more quickly and give you poor braking performance. In addition, brake dust can build up on the calipers and rot over time. A brake fluid flush will clean all of this gunk away and restore your car’s braking system to its original condition.
When is Brake Fluid Flush Required?
Brake fluid flush is typically required when the brake system has been exposed to high temperature or direct sunlight.
Benefits of Brake Fluid Flush
Brake fluid flush is a routine maintenance procedure that can help to improve braking performance and prolong the life of your brake pads. Brake fluid is a mixture of water, organic compounds, and detergents that helps to reduce friction between the pads and the rotors. Over time, brake fluid can become contaminated with dust, dirt, and other debris. A brake fluid flush can help to remove these contaminants and restore the brake system to its factory condition.
There are several benefits to performing a brake fluid flush. First, a brake fluid flush can help to improve braking performance. By removing the residue and contaminants from the brake system, the brakes will operate more smoothly and stop more quickly. Second, a brake fluid flush can prolong the life of your brake pads. By cleaning the system of contaminants, your pads will be less likely to wear down over time. Finally, a brake fluid flush can help to protect against corrosion in the braking system. By removing build-up of debris and moisture, corrosion is less likely to occur.
Steps to Perform a Brake Fluid Flush
A brake fluid flush is a necessary maintenance procedure on most vehicles. Brake fluid is used to force the pistons of the brake calipers to move the pads against the rotor, stopping the car. Brake fluid can become contaminated with moisture and dust, which can lead to brake pad wear and decreased braking performance. A brake fluid flush removes any contaminants from the brake system and restores it to its factory condition.
The following steps should be followed in order to perform a brake fluid flush:
1) Shut off the engine and remove the key from the ignition.
2) Open the hood and remove the front bumper cover.
3) Remove the two screws that hold down the caliper bracket.
4) Lift off the caliper bracket.
5) Remove the two bolts that hold down the caliper.
6) Disconnect the hose that attaches to the master cylinder reservoir.
7) Loosen or remove (as necessary) all hoses connected to each caliper.
8) Place a container underneath each caliper so that brake fluid can drain away easily.
9) Position each caliper so that its pistons are