Brakes work by slowing down or stopping a car, so it’s important to keep them working properly. A brake fluid flush can help ensure that your brakes are working at their best, and while it may seem like a simple task, getting one done correctly can be tricky. In this article, we’ll walk you through the steps involved in getting a brake fluid flush done correctly and why it’s important.
What is a brake fluid flush?
Brake fluid flush is a service that is offered by many car repair shops. Brake fluid flush is simply a procedure where the brake fluid in your car is replaced. The purpose of this service is to prevent corrosion and wear on your braking system.
When to do a brake fluid flush?
Depending on the age of your vehicle and the condition of your brakes, you may need to do a brake fluid flush at some point. A brake fluid flush is a simple procedure that cleanse and lubricate the braking system. Follow these guidelines to determine when and how to perform a brake fluid flush:
-If your braking system needs attention, schedule a brake fluid flush as soon as possible. Brake fluid can become contaminated with rust and other debris over time, leading to decreased braking performance.
-If you experience any abnormal noise or grinding while braking, schedule a brake fluid flush immediately. This could indicate that your brakes are in need of replacement or maintenance.
-If your vehicle has been in an accident or experienced heavy use, you may need to do a brake fluid flush as part of the regular maintenance process. This is especially true if your brakes have been exposed to water or moisture.
What to expect during a brake fluid flush
You may be wondering what to expect during a brake fluid flush. Knowing what to expect can help make the process go smoother. Here are some key points to keep in mind:
-The technician will use a hose to fill your brake system with fluid.
-Be prepared for the fluid to be a light brown or yellow color.
-The work will take around 30 minutes, and you may experience a bit of noise during the process.
How to do a brake fluid flush
If you’re experiencing a juddering, grinding, or shuddering when you brake, it may be time to give your brakes a flush. Brake fluid can become contaminated with build-up over time, leading to performance issues and safety concerns. To do a brake fluid flush on your own, follow these simple steps:
1) Park the car in a safe location and turn off the ignition.
2) Remove the front and rear brake pads by pulling them out from the caliper and then pulling up on the hanger bar.
3) Remove the two cap screws holding the master cylinder in place and then remove the entire master cylinder.
4) Disconnect the lines going to the reservoir (or if you have a dual reservoir system, disconnect both reservoirs).
5) Pour a little bit of DOT 3 brake fluid into each of the two bleeders (or if you have a dual reservoir system, pour some into both bleeders). Make sure that there is enough fluid in each bleeder to cover the piston inside. If there isn’t enough fluid, add more until there is.
6) Replace each piston by sliding it into its retaining nut and tightening it down using a