Jacking up a car is a common task that many people have to do from time to time. It’s a quick and easy way to get the car up in the air so that you can fix something or remove something. But there are a few things you should know before you start jack-knifing your car.
What You’ll Need
If you’re looking to jack up the back of a car, you’ll need some supplies. The most important thing is a sturdy jack. You’ll also need some heavy-duty straps, a ratchet set, and a wrench.
You can find all of these supplies at most hardware stores. The jack will likely cost the most, and you might also need to buy the straps and wrench separately.
Instructions
1. To jack up a car, first find the bolt that attaches the springs to the car frame. This is usually a hexagonal bolt with a wing nut on either side.
2. Remove the bolt and the springs.
3. Place one end of an pickup truck bed rail on top of the car’s spring strut and rest the other end on your foot so it’s level with your shoulder.
4. Drive your pickup truck up onto the rail, until you feel it start to bend. Keep applying pressure until you pop the spring strut off of the car frame.
5. Repeat on the other side.
Tips for Safe Jacking
When you’re ready to jack up your car, make sure to use safe practices to ensure your safety and that of others. Here are some tips:
1. Use a designated spot. Find a safe, flat place to jack your car up before starting. If you’re not sure where to find a safe spot, check with your local police department or automobile club.
2. Dress properly. Wear clothes that cover your arms and legs and work gloves if you plan on using hand tools while jacking up the car. Sharpen your tools before you start if necessary.
3. Use a lift/truck or hoist. Using a lift or hoist is the safest way to jack up a car. Make sure the equipment is in good condition and use caution when lifting the car so it doesn’t move or touch any wires or other electrical equipment nearby.
4. Know your limits. Don’t try to jack up a car if you’re not comfortable doing so. If something goes wrong, you’ll have less chance of injuring yourself or others
The Final Result
Do you want to lift the back of your car and increase its height? If so, you’re in luck because this is an easy task that can be accomplished with a jack and some help from a friend.
Before you begin, it’s important to know the dimensions of your car. This information can be found on the door jamb or inside the trunk. Once you have this information, you can begin to plan out how to do the job.
The first step is to jack up the car using a sturdy jack. Make sure that the jack is level and that the axle is centered between the two supporting points on the bottom of the car. Next, get your friend to help you by placing his or her hands under the car and lifting it upward. Once it’s off of the ground, move it to a safe place so that you don’t injure yourself or damage your vehicle.
Now that you’ve successfully lifted your car, it’s time to take advantage of its newfound height. You can raise your car using straps or blocks if necessary, but make sure that you’re comfortable doing so before starting. Be careful not to damage your car while raising it and remember to remove all of the straps or blocks once you