If your Chevy Hhr is feeling a little off-kilter, it might be time to check the power steering fluid level. Power steering fluid helps to provide friction and assistance when turning the wheel, so it’s important to keep it topped off. Here are instructions on where to put power steering fluid in a Chevy Hhr.
Identification
Power steering fluid (PSF) is important in a Chevy HHR because it helps the car steer. The fluid is usually stored in the reservoir under the car near the engine. It’s usually a black or dark color and should have a viscosity of around 40 cps. You can check to see if your reservoir needs to be filled by turning the car on and looking for the PSF indicator light next to the fuel gauge. If it’s not on, then your reservoir is empty and you need to fill it.
How to Put Power Steering Fluid In Chevy Hhr
If your Chevy HHR is experiencing power steering problems, it’s time to fix them. Power steering fluid is a critical component of your car’s system and should be changed regularly, even if the system looks normal on the surface. Follow these steps to change the power steering fluid in a Chevy HHR:
1) Open the hood of your car. The power steering fluid reservoir should be located in the lower right corner of the engine compartment. Use a wrench to unscrew the cap. Make sure to replace any old fluid with fresh power steering fluid before refilling.
2) Pour 3 quarts of power steering fluid into the reservoir. Replace the cap and screw it tight. Make sure to readjust any hoses connected to the reservoir while you’re filling it.
3) Drive your car around for a few minutes to distribute the new fluid throughout the system. If you have an automatic transmission, you may also need to change the torque converter fluid at this time.
Conclusion
If you’re having trouble locating the power steering fluid reservoir in your Chevy Hhr, here are some tips on where to put it. In order to prevent fluid loss and damage to your engine, it’s important to keep the reservoir full. To find the reservoir, start by looking under the hood near the driver’s side wheel well. Next, locate the bolt that holds down the air intake ducts and remove it. The reservoir will be located beneath this metal bracket. Once you’ve found it, replace the bolt and tighten it using a socket or wrench.