Honda Power Steering Reservoir is a component that can fail in your Honda Accord. It is not uncommon for this part to need to be replaced, and when it does, you will be glad you paid attention to our guide on how to replace it. Our article will teach you how to remove and replace the Honda Power Steering Reservoir in your Accord.
Honda Power Steering Reservoir Replacement Cost
If you are thinking about replacing your Honda power steering reservoir, there are a few things to keep in mind. The reservoir is a common failure point on Hondas and can lead to decreased power and decreased steering response. Here are the estimated costs of a Honda power steering reservoir replacement:
– Replacement of the reservoir itself can cost around $200-$300
– Depending on the model, other components may also need to be replaced, such as hoses or seals. This can add an additional $100-$200 to the overall cost.
Honda Power Steering Reservoir Inspection
Honda power steering reservoirs can become clogged with sediment, which will eventually cause the reservoir to fail. A Honda power steering reservoir inspection can help determine if the reservoir needs to be replaced.
Symptoms of a Honda Power Steering Reservoir Failure
If you are experiencing any of the following symptoms, it is likely that your Honda power steering reservoir is failing and needs to be replaced:
-A loss of power steering fluid or difficulty steering
-A rattling or grinding noise from the power steering system
-A decrease in engine performance
-A pinging noise when turning the wheel
If you notice any of these symptoms, it is recommended that you schedule a service appointment as soon as possible. A failing Honda power steering reservoir can lead to more serious issues, including loss of vehicle control and even a crash.
Honda Power Steering Reservoir Repair Procedure
If your Honda power steering reservoir is leaking, you will need to replace it. Here is a procedure for replacing the reservoir:
1. Jack up the vehicle and remove the wheel.
2. Remove the power steering pump cover by gently prying it off with a flathead screwdriver.
3. Remove the two bolts that hold the power steering pump in place and set them aside.
4. Remove the power steering reservoir by unscrewing the eight screws that hold it in place. Be careful not to lose any of the sealing gaskets in the process.
5. Replace the power steering reservoir with a new one and re-install the screws and bolts. Be sure to use sealant on all bolts and screws before reinstalling them to prevent leaks in the future.