Are you using Plasti Dip to protect your wheels before painting them? If so, be sure to read this article first! Wheel cleaners are often formulated with harsh chemicals that can damage Plasti Dip. In addition, certain abrasive cleaners can also cause scratches or etches in the finish. Before using any wheel cleaning product, always test it on a small inconspicuous area first.
What is Plasti Dip?
Plasti Dip is a type of temporary adhesive that can be used to seal and protect surfaces from scratches, chips and dings. It is made up of polyester resin and hardener.
If you are using a wheel cleaner on Plasti Dip, it is important to keep in mind the following:
First, always test the cleaner on a small patch of the adhesive first to make sure it will not damage the material. Second, do not use too much cleaner at once; instead, slowly work it into the adhesive with a Microfiber towel. Third, avoid scrubbing or rubbing the cleaner directly against the Plasti Dip; instead, use gentle back-and-forth motions with the towel. Fourth, allow the cleaner to dry completely before using the adhesive again. Fifth, be careful when cleaning plastic trim around your wheels – be sure to use a cloth rather than a sponge to avoid scratching the trim.
How is Wheel Cleaner Different from Other Cleaners?
One of the most common questions that we get asked at our store is “will wheel cleaner damage my plasti dip?” The answer to this question is a little bit different for each person, as some people believe that wheel cleaner is just as effective as other cleaners when it comes to removing dried on residue, while others believe that wheel cleaner is more effective because it has a stronger scent.
There are a few things to consider when it comes to using wheel cleaner on plasti dip. First and foremost, the concentration of the cleaner should be high enough to break down dried on residue but not so high that it will damage the plastic. Secondly, the pH of the cleaner should be close to neutral so that it doesn’t cause any damage to the plastic. Finally, make sure to use caution when spraying around sharp edges or moving the vehicle because the cleaner could cause scratches.
Can Wheel Cleaner Damage Plasti Dip?
Yes, wheel cleaner can damage plasti dip. The acids in the wheel cleaner can etch the plastic away, leaving a porous surface that can allow water and stains to penetrate. In extreme cases, this could lead to a full-on rip-off of your plasti dip project.
To avoid damaging your plasti dip project, always use a gentle wheel cleaner and rinse the area thoroughly afterward. Also be sure to dry the area completely before applying any additional sealants or paint.
Conclusion
Yes, wheel cleaner can damage Plasti Dip. However, the cleanliness of your wheels will also protect Plasti Dip from further damage. Follow these steps to keep your Plasti Dip looking its best: 1) Use a diluted solution of soap and water instead of wheel cleaner. This will help to reduce the chance of any chemical burns or glazing on your finish. 2) Let your Plasti Dip dry completely before you apply a new coat. This will help to prevent any water droplets from creating bubbles that could cause peeling or chipping.